Edimax-technology PS-1210Un User Manual download pdf (Page 63)

6.3.2 BOOTP

If you have the BOOTP daemon, bootpd, running on your

UNIX system that is accessible by the print server, you

can use the BOOTP protocol to set up the IP address of

the print server. We recommend that the BOOTP server

should be located on the same subnet as the print server.

If you use Network Information Services (NIS) in your

system, you may need to rebuild the NIS map with the

BOOTP services before doing the following BOOTP

configuration. To rebuild the NIS map, please refer to your

system documentation.

To configure the IP address data for the BOOTP server,

you will need to log in the host of BOOTP server as the

superuser (root). Perform the following steps to add

address entries,

1. Optionally, assign a name corresponding to the print

server’s IP address. You can add this address to the

/etc/hosts file, by adding a line such as:

203.66.191.12 pserver

2. Add an entry to the host’s /etc/bootptab file, similar to

the following:

hostname:\

:ht=1:\

:ha=print_server_ethernet_address:\

:ip=print_server_ip_address:

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 158 159

No comments

Edimax-technology PS-1210Un User Manual Page 63